7. If you want to add additional steps, repeat 4, 5 & 6 until you have added all the desired steps in your
entire chase.
8. Exit Record Mode.
**There are maximum of 99 steps in 1 chase. 16 chases can hold a maximum of 392 steps**
Delete a Step from an Existing Chase:
1. Enter Record Mode by pressing the Record button.
2. Select the chase from which you want to delete a step.
3. Use the Mode/Up and Patch/Down buttons to scroll through the chase and select the step you want to
delete.
4. Push the TAP/SYNC button to delete the step. All LEDs will flash 3 times indicating the step has been
successfully deleted.
5. Continue this procedure (steps 2, 3 & 4) if you want to delete multiple steps.
Auto/Music/Manual Mode:
Auto:
1. Press the Mode button until the LED in front of Auto lights up green.
2. You can control the speed and fade time but adjusting the Speed and Fade Time fader.
Music:
1. Press the Mode button until the LED in front of Music lights up green.
2. You can control the audio sensitivity by adjusting the Audio fader.
**Fade Time is not available in Music Mode**
Manual:
1. Press the Mode button until the LED in front of Manual lights up green.
2. With TAP/SYNC you can manually go through the chase steps.
**Fade Time is not available in Manual Mode**
Strobe Mode:
1. Press the Strobe button to enter Strobe Mode.
2. You can control the strobe speed with the Speed fader.
3. To exit the Strobe Mode, make sure the speed fader is at 0. Now press the Strobe button to exit the Strobe
Mode.
**Strobe cannot be recorded in a scene or chase**
The fixture channel sliders are patchable to different DMX addresses. See below on how to assign these:
Channel Assignment:
1. Scene buttons 1-8 are DMX channels 1-8.
2. Press and hold the Patch/Down button for 5 seconds. The Patch LED will light up red.
3. Press the fixture button you desire. The Fixture LED will light up blue. You can choose 4 different fixtures.
4. Press and release the channel flash button (red, green, blue or dimmer) and push the Scene button that
refers to the channel you want to patch. First, press the channel flash button then press the Scene
button to save the DMX channel. All LEDs will flash.
5. Press Patch button for 5 seconds to exit Patch Mode.
Factory Reset:
1. Turn off the device.
2. Press and hold the Record button & TAP/SYNC together.
3. Switch the device back on.
4. The display will show 88 for 10 seconds.
5. After that all LEDs will flash 3 times.
6. The display will now show 00
**After the factory reset the fixture is auto patched**
(10 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji